Design for high precision (diameter: 70 mm - 400 mm)
Milled technology is very suitable for small and medium-sized precision parts.
Our feeders are designed and produced on 3D CAD basis.
CAD data simplify interface definitions between the feeder module and the machine
Our milled feeder bowls have a very large repeatability degree.
Spare and wear parts can also be reproduced subsequently in most cases and replaced with plug and play and put into operation with minimal fine adjustment work.
Design for high precision (Ø 70 mm - 400 mm)
These feeder bowls are available in single-lane or multi-lane versions.
The conventional design is suitable for simple to complex molded parts, the special design for simple to moderately difficult molded parts:
with/without sorting chicane
with/without sensor system or camera
with/without separation system
special design from 2 to 10 lanes possible
capacity up to 10 pcs./sec. or 600 pcs./min.
Suitable for all kinds of flat and round parts with complex three-dimensional geometry (molded plastic injection parts or stamped/bent parts, etc.), such as:
Nuts, bolts
Stamped parts, bent parts
turned parts, pins, sleeves
washers, rings, O-rings
Balls, stones, diamonds
The download area is only available to registered users.
The company ARCOZ AG offers products and complete solutions made to measure around the special machine construction.
